Radiation protective clothing is mainly used to protect human body from radiation hazards. However, if our anti radiation clothing has quality problems or is damaged, it will increase the harm of radiation to human body and cannot better protect human health. Before wearing protective clothing, it is necessary to do some inspection work. Only in this way can it be convenient for future use. Then what inspection work is there before wearing protective clothing? The following is a brief introduction.
I. there are holes, cuts and damages on the surface of X-ray protective clothing, which need to be checked by hand lamp. However, it should be noted that the clothing pinhole covered by the adhesive strip is not a defect, and it is also necessary to check whether the adhesive strip is warped or the seam is not sealed enough.
Second, before the test, they can wear protective clothing, and do not use chemical protective clothing for pollution, damage or deformation. It is recommended that the protective clothing store track and check the radiation protective clothing every year. You can also use iodine to confirm the physical decomposition, apply iodine wine to the suspicious area, and then wipe off the excess iodine with a thousand wool towel. If there are traces of dark coffee left, the protective layer will break. This protective clothing is not up to standard.
3. Check whether the sealing of the mask is reliable and ensure that the vision in the mask is clear. Check the air supply system of radiation protective clothing to ensure that it is connected normally and works normally. Check the gloves of the protective clothing to ensure that they work properly. If the gloves are attached to the protective clothing, check the interface between the gloves and the protective clothing. If the boots are connected to the suit, check the interface between the boots and the suit.
The above is about the inspection before wearing the radiation suit. I hope it can help you.