鉴于射线防护门的特殊防辐射功能，在具体施工的时候注意以下的小小安装技巧：
In view of the special radiation protection function of the radiation protection door, pay attention to the following small installation skills during the specific construction:
1、把做好的射线防护门放入到门洞内(必要时把门扇拆下),使射线防护门包边内面与接触面贴合墙体并垂直,必要时纠正墙体表平面。
1. Put the radiation protection door into the door opening (remove the door leaf if necessary), make the inner surface of the edge of the radiation protection door and the contact surface fit the wall and vertical, and correct the surface of the wall if necessary.
2、对射线防护门侧框体进行垂直定位,必须做到点面在同一平面上.
2. For the vertical positioning of the side frame of the radiation protection door, the point plane must be on the same plane
3、对射线防护门的铰位侧框体进行固位,拉爆、固位或拉片固位,必需安装牢固。
3. The hinged side frame of the radiation protection door shall be fixed, blasted, fixed or clamped firmly.
4、调整锁位宽体垂直位置,使门扇同门框之间的间隙位置达到均匀一致,并做更终的固定。
4. Adjust the vertical position of the lock position wide body to make the gap between the door leaf and the door frame uniform and make the final fixation.
5、待水泥浆或发泡胶干燥后,取下间隙片及其垫板即可。
5. After the cement slurry or styrofoam is dried, remove the clearance piece and its base plate.
6、更要要注意检查所需安装的射线防护门,检查及其开关是否灵活顺畅，确定门开关顺畅后，再用铅板或者硫酸钡防护涂料将门口墙面及门墙缝隙处理密封，保证射线不外泄就OK了。
6. The most important thing is to check the ray protection door that needs to be installed, check whether its switch is flexible and smooth. After confirming that the door switch is smooth, use lead plate or barium sulfate protective coating to seal the door wall and the door wall gap, so as to ensure that the ray does not leak.
This article is dedicated to radiation protection equipment. For more information, please click: http://www.jnlzsb.com Sincere attitude. For you to provide a comprehensive service. More relevant knowledge we will continue to dedicate to you. Please look forward to
18678809986
