欢迎光临!济南联众供热设备厂,主营:山东燃气锅炉山东电采暖锅炉山东多介质过滤器和射线防护器材等。
  • 服务热线:18678809986
  • 首页 关于我们 产品中心 新闻中心 工程案例 设备选型 联系我们
  • 您的位置:首页> 新闻中心

    安装射线防护门需要注意哪些点?
    来源:http://www.jnlzsb.com 发布时间:2020-09-26

    医用防护门一半是采用屏蔽保护和距离保护的原则,屏蔽保护指的就是原材料使用含有铅的物质,射线防护门-医用防护门-辐射防护门-手术室气密门-山东嘉乾金属材料有限公司因为铅的原子序数是比较高的,可以吸收对人体有危害的射线的照射。
    Half of the medical protective doors adopt the principles of shielding protection and distance protection. Shielding protection refers to the use of materials containing lead in raw materials. Radiation protection doors - medical protection doors - radiation protection doors - operating room airtight doors - Shandong Jiaqian metal materials Co., Ltd. can absorb the radiation that is harmful to human body because of the high atomic number of lead.
    距离保护是通过射线的照射量与距离平方成反比的原理,辐射防护门的小知识通过增加射线照射与人员之间的距离,自动气密门,自动气密门如果是过多的X射线照射超过了人体所能承受的照射量的话,可能就会发生辐射反应,甚可能在在一定的程度上造成辐射的损伤。
    Distance protection is based on the principle that the radiation dose is inversely proportional to the square of the distance. The small knowledge of the radiation protection door increases the distance between the radiation and the personnel. The automatic air tight door and the automatic air tight door may cause radiation reaction and even cause radiation to a certain extent if the radiation is too much than the human body can bear Injury.
    所有就这需要在射线辐射强的地方,安装医用防护门,有些人会比较抗拒去X光和CT的检查,其实辐射在医用防护门阻隔后,射线对人体的造成的伤害是在人们可承受的范围之内的。
    射线防护器材
    Therefore, it is necessary to install medical protective doors in places with strong radiation. Some people will resist the examination of X-ray and CT. In fact, after the radiation is blocked by the medical protective door, the damage caused by radiation to human body is within the scope that people can bear.
    射线防护门
    Radiation protection door
    1,把做好的射线防护门放入到门洞内,医用防护门生产化但是必要时可以把门扇拆下,分类2使射线防护门包边内面与接触面贴合墙体并垂直,必要时纠正墙体表平面。
    1. Put the finished radiation protection door into the door opening, and the production of medical protection door is specialized, but the door leaf can be removed if necessary. Classification 2 makes the inner surface of the radiation protection door and the contact surface fit the wall and be vertical, and correct the surface plane of the wall if necessary.
    2,射线防护门-医用防护门-辐射防护门-手术室气密门-山东嘉乾金属材料有限公司对射线防护门侧框体进行垂直定位,做到点面在同一平面上。
    2. Ray protection door - medical protection door - radiation protection door - air tight door of operating room - Shandong Jiaqian metal materials Co., Ltd. vertically positioned the side frame of radiation protection door, so that the point and plane are on the same plane.
    3,医用防护门生产化射线防护门门框就位后,分类2门框用螺栓临时固定,分类2按设计要求调整安装高度一致,与内,外墙面距离一致,门框上下宽度一致。
    3. After the door frame of specialized radiation protection door production is in place, the door frame of category 2 is temporarily fixed with bolts, and category 2 is adjusted according to the design requirements to the same installation height, the same distance with the inner and outer walls, and the same width of the upper and lower door frames.
    4,安装射线防护门时要调整锁位宽体垂直位置,使门扇同门框之间的间隙位置达到均匀一致,并做固定。
    4. When installing the ray protection door, the vertical position of the locking wide body should be adjusted to make the gap between the door leaf and the door frame uniform, and fixed.
    5,门框用螺栓临时固定,应进行复核,以保证安装尺寸准确。
    5. The door frame is temporarily fixed with bolts, which shall be rechecked to ensure the accurate installation dimension.

    鲁公网安备 37011302000227号