避免热水锅炉出现汽化现象的措施
    2017-8-29 16:54:18  文章来源:http://www.jnlzsb.com

    山东燃气锅炉中常用的小火检火器通常都是电离式火检,若是想正常发挥作用的话,就要求其必须与火焰有一个有效接触面积,同时还要保持火焰大小合适稳定,而锅炉中的燃气压力必须严格控制在一个规定的范围内。

    In the small biomass boiler flame detection is usually used for firearms ionization type flame detector, if you want to play a role in the normal case, the request must have a valid contact area and fire, but also keep the flame size is stable, and the gas pressure in the boiler must be strictly controlled within a specified range.

    在实际应用中发现,生物质锅炉有时候点起火来会十分的困难,其主要原因就是锅炉中无法建立稳定的小火信号,而追根究底则是生物质锅炉中小火的检火器没有正常发挥检火的作用,才会导致类似现象的产生。

    In the practical application, the biomass boiler sometimes fire to be very difficult, small fire signal stability cannot be established is the main reason why the boiler, and there is a small fire firearm seized biomass boiler without the normal inspection play the role of fire will lead to similar phenomena.

    除了燃气压力大小控制不当造成的无法点火,分析证实生物质锅炉小火的燃气压力调节的阀门调节性能不佳,无法实现精细调节;锅炉进气风门大小配比、锅炉炉膛负压等也与无法点火有关。因为风门过大过小都会影响到火焰是否能够点着且火焰稳定,炉膛负压过大也会导致火焰的熄灭。

    In addition to the ignition control caused by improper gas pressure, gas pressure analysis confirmed that the biomass boiler small fire regulating valve performance is poor, unable to realize the fine adjustment of boiler; air intake size ratio, negative pressure and so on to ignition. Because the air door is too small, will affect the flame can point, and the flame is stable, too much negative pressure in the furnace will lead to the extinction of the flame.

    环保采暖锅炉

    如果生物质锅炉启动之后炉内的燃气压力过大,那么小火的火焰就会前移过长,从而脱离了小火检验探头的检测范围,导致系统误认为无小火。另一种另外,如果生物质锅炉的燃气压力过小,则会造成进入的点火气过小,而锅炉内鼓风较大,容易吹灭火焰,因而无法点火。

    If the gas pressure in the furnace is too large after the startup of the biomass boiler, the flame of the small flame will move forward too long, thus leaving the detection range of the small fire detector and causing the system to be mistaken for no small fire. In addition, if the gas pressure of the biomass boiler is too small, the ignition gas is too small, and the blast in the boiler is larger, and the flame can be easily blown out so that the ignition can not be ignited.

    若是想保证生物质锅炉火焰检测的准确性,可以调整小火火检探头插入深度,使火检探头位置处于恰当的位置,以便更有效地检测到小火火焰,避免锅炉无法点火。

    If you want to ensure the accuracy of biomass boiler flame detection, can adjust the small fire detecting probe insertion depth, so that the flame detecting probe position is in the proper position, in order to more effectively detect a small fire, can not avoid the boiler ignition.

    为了避免热水锅炉出现汽化现象,首先要加强对锅炉的维修和保养,尤其是水泵传动部件、轴承等部位必须完好,电力端子接必须规范牢固,防止脱落缺顶烧坏电机。

    In order to avoid hot water boiler vaporization phenomenon, we must first strengthen the boiler repair and maintenance, especially the pump drive components, bearings and other parts must be in good condition, the power terminal must be standardized and firm, to prevent the shedding of Lacunary motor burn.

    本文由山东燃气锅炉友情奉献.更多有关的知识请点击:http://www.jnlzsb.com/我们将用最先进的技术.最真诚的态度.为您提供最为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

    In this paper, Shandong gas boiler friendship devotion. More related knowledge please click: http://www.jnlzsb.com/ we will use the most advanced technology. The most sincere attitude, to provide you with the most comprehensive service. More related knowledge and we will continue to offer. Please look forward to.