欢迎光临!济南联众供热设备厂,主营:山东燃气锅炉山东电采暖锅炉山东多介质过滤器和射线防护器材等。
  • 服务热线:18678809986
  • 首页 关于我们 产品中心 新闻中心 工程案例 设备选型 联系我们
  • 您的位置:首页> 新闻中心

    不锈钢过滤器滤芯的保养应该注意什么?
    来源:http://www.jnlzsb.com 发布时间:2020-10-20

    1.不锈钢过滤器长期未得以应用时,我们必须要将过滤器内部的滤液排放干净,然后将滤芯拿出,进行洗净烘干流程,当完成这一系列操作后,将产品放入干净的塑料袋内并封口,这是为了保证滤芯产品不被污染.,将不锈钢过滤器擦净存放于干燥处即可.
    1. When the stainless steel filter has not been used for a long time, we must discharge the filtrate inside the filter, and then take out the filter element for cleaning and drying process. After completing this series of operations, put the product into a clean plastic bag and seal it to ensure that the filter element product is not polluted. Finally, clean the stainless steel filter and store it in a dry place
    2.一般,换下来的滤芯要浸泡于酸性强度强的洗液中,浸泡时长约为24小时左右,切记,酸性液体的温度要保持于25-50度左右,在进行浸泡的过程中时,我们建议酸与碱占液体的比例要控制在20%之间,这是为了避免液体对滤芯产品内部的破坏与污染.
    2. Generally, the replaced filter element should be immersed in strong acid detergent for about 24 hours. Remember that the temperature of acid liquid should be kept at about 25-50 degrees. In the process of soaking, we suggest that the ratio of acid and alkali to liquid should be controlled between 20%, which is to avoid the damage and pollution of the liquid to the filter element
    山东多介质过滤器
    3.一般而言,蛋白因子较高的洗液产品好,不管是从清洁度上还是节约上而言,效果都很好.因此,应当利用蛋白含量较高的酶溶液进行清洗.当清理过后,一定要进行二次清洗,并采用蒸汽进行整体,这流程对过滤器的保养更为重要.
    3. Generally speaking, the detergent with high protein factor is good, and the effect is good both in terms of cleanliness and economy. Therefore, enzyme solution with high protein content should be used for cleaning. After cleaning, it is necessary to carry out secondary cleaning and steam disinfection, which is the most important process for the maintenance of the filter
    4.不锈钢过滤器在过程中要注意一定的时间和温度,通常,内部的滤芯产品要在柜中放置130℃/20分钟,温度不宜超过150℃,更长时间不能超过30分钟.要切记,一旦温度过高,抑或时间长、压力大,都会导致过滤器内部元件(滤芯)的整体损坏.
    4. Pay attention to certain time and temperature in the process of disinfection of stainless steel filter. Generally, the internal filter element should be placed in the disinfection cabinet at 130 ℃ / 20 minutes. The disinfection temperature should not exceed 150 ℃ and the longest disinfection time should not exceed 30 minutes. It should be noted that once the disinfection temperature is too high, or the time is long and the pressure is high, the internal components (filter element) of the filter will be damaged
    由此可见,无论是不锈钢过滤器滤芯的清洗还是长期不使用之后的维护与保养工作,其步骤都异常复杂,我们需要多多了解其中的细节部分才能真正掌握其中的诀窍.
    It can be seen that whether it is the cleaning of stainless steel filter element or the maintenance after long-term non use, the steps are extremely complex. We need to know more about the details to really grasp the knack
    以上的内容就是山东多介质过滤器为大家介绍的今日内容,更多内容还请大家关注网站:http://www.jnlzsb.com我们会定期更新新的知识与内容为大家呈现.
    The above content is the content of today introduced by Shandong multi-media filter. For more information, please pay attention to the website: http://www.jnlzsb.com We will regularly update new knowledge and content for you to present

    鲁公网安备 37011302000227号