欢迎光临!济南联众供热设备厂,主营:山东燃气锅炉山东电采暖锅炉山东多介质过滤器和射线防护器材等。
  • 服务热线:18678809986
  • 首页 关于我们 产品中心 新闻中心 工程案例 设备选型 联系我们
  • 您的位置:首页> 新闻中心 >

    电采暖锅炉影响使用效果的因素有哪些?
    来源:http://www.jnlzsb.com 发布时间:2020-10-26

    安全装置检测正常火灾的检查
    Inspection of safety device for detecting normal fire
    吹掉正常火,加热炉应在45秒内切断。 温度限制保护87°C
    Blow out the normal fire, the heating furnace should be cut off within 45 seconds. Temperature limit protection 87 ° C
    电磁加热炉的加热温度升至87°C,主燃烧器将自动熄灭。 当温度下降约10°C时,加热炉将自动工作。 电源(检测)失败
    When the heating temperature of the electromagnetic heating furnace rises to 87 ° C, the main burner will automatically extinguish. When the temperature drops by about 10 ° C, the furnace will operate automatically. Power failure
    电磁加热炉处于工作状态,加热炉在供电后自动工作。 过热保护检测
    The electromagnetic heating furnace is in working state, and the heating furnace works automatically after power supply. Overheat protection detection
    拔下过热保护的上部连接插头,加热炉应停止工作。 加热温度限制保护
    Pull out the upper connecting plug of overheat protection, and the heating furnace should stop working. Heating temperature limit protection
    拔下温度限制保护线,主燃烧器应立即熄灭。 防堵塞检测
    The main burner shall be extinguished immediately after the temperature limit protection wire is pulled out. Anti clogging detection
    阻塞烟道,主燃烧器应立即熄灭。
    If the flue is blocked, the main burner should be extinguished immediately.
    其他检测加热循环中的水压
    Other tests for water pressure in heating cycle
    山东电采暖锅炉
    加热循环中的水压应为1.5巴左右,水压应高于1巴。 卫生热水温度
    The water pressure in the heating cycle should be about 1.5 bar, and the water pressure should be higher than 1 bar. Sanitary hot water temperature
    如果卫生热水流量不足,请检查冷水进水管中的过滤器。 加热温度升高
    If the sanitary hot water flow is insufficient, check the filter in the cold water inlet pipe. Heating temperature rise
    如果温度上升过快,请检查旁通阀或回水处过滤器的调节情况。 膨胀水箱
    If the temperature rises too fast, check the adjustment of the bypass valve or the filter at the return water. Expansion tank
    当加热功能运行时,如果加热循环水中的水压上升过快,检查膨胀水箱的压力。 在这种情况下,连接板的加热水出口和回水阀关闭,加热炉中的水通过加热排水阀排出,膨胀水箱的压力应在0.5到0.6巴之间。
    When the heating function is running, if the water pressure in the heating circulating water rises too fast, check the pressure of the expansion tank. In this case, the heating water outlet and return valve of the connecting plate are closed, the water in the heating furnace is discharged through the heating drainage valve, and the pressure of the expansion tank should be between 0.5 and 0.6 bar.
    检查卫生用水功能,检查卫生用水,加热炉处于夏季功能位置。
    Check the function of sanitary water, and check that the heating furnace is in the functional position in summer.
    检查燃烧器的点火状况;
    Check the ignition condition of burner;
    二次检查卫生用水,加热炉处于冬季功能位置。
    The heating furnace is in the functional position in winter.
    检查燃烧器的点火状况;
    Check the ignition condition of burner;
    检查加热炉的卫生水调节功能; 在低进气量的条件下运行卫生用水功能,检测气体量的变化和水温的变化。
    Check the sanitary water regulation function of the heating furnace; operate the sanitary water function under the condition of low air intake to detect the change of gas quantity and water temperature.
    只有把上述所讲的内容设定好,我们的操作才算完成,如果您这边在后续的过程中有任何的问题,欢迎致电或者是在网站上边留言:山东电采暖锅炉http://www.jnlzsb.com
    If you have any problems in the follow-up process, please call or leave a message on the website: Shandong electric heating boiler http://www.jnlzsb.com

    鲁公网安备 37011302000227号